Steinel IS 360 User Manual download pdf (Page 3)

Setup & Commissioning

Wiring

Operation

L

O

A

D

LINE (BLACK)

NEUTRAL

Local OFF

Switch (optional)

HOT

NEUTRAL (WHITE)

LOAD (RED)

When installing, make sure power has been

switched off at the breaker and check that

the circuit is dead with a voltage tester. The

leads consist of three wires:

Black L IN = hot wire

Red L OUT = switched hot wire for ﬁ xture

White N = neutral wire. Connect N (white)

with the neutral wire (usually white)

Connect L OUT (red) with the hot wire of the

ﬁ xture (usually black.) Connect L (black)

with the hot wire of the supply lead (usually

black.)

Test mode

• Ensure that the sensor is in test mode.

- set time delay to position 1

(minimum setting of 10 sec).

- set light level to position 1 (light level

function overridden).

• Turn power ON at the circuit breaker

(lights will turn ON). After a warm up

period of up to one minute, lights will

turn OFF if the sensor does not detect

motion.

• Walk in view of sensor, lights should

turn ON. Be still for 10 seconds and

lights should turn OFF.

Light level

The light level feature

allows lighting to remain

OFF during daylight,

regardless of occupancy.

Daytime operation is

at 200 footcandles

(factory setting) with the

adjustment set at position 1. Nighttime

operation, .2 footcandles, is at position 6.

Time delay

Time delay is the period

of time lights remain

on after a space is left

unoccupied. Adjustment

ranges from 10 sec

(factory setting) to 15

min.

After setup and commissioning tests are

complete, adjust the time delay and light

level settings to ﬁ t your application needs.

Light LevelTime Delay

L

O

A

D

L

O

A

D

LINE (BLACK)

NEUTRAL

Local OFF

Switch (optional)

HOT

NEUTRAL (WHITE)

LOAD (RED)

LINE (BLACK)

NEUTRAL (WHITE)

LOAD (RED)

5

.2 - 200 fc

10 sec - 15 min

The IS 360 operates by turning lights on

automatically when occupancy is detected

and off when the space is left vacant and

the time delay has elapsed.

The light level feature keeps lighting

off during daylight hours, regardless of

occupancy.

Adding a wall switch provides a manual

override function. While the switch is ON,

the sensor is in occupancy control mode.

Users can turn the switch OFF at any time

to keep lights OFF.

Mounting

Fastening screw

Placement guidelines

• Intended for surface mounting under

sofﬁ t (exterior) or on ceiling (interior)

• Ideal outdoor placement for the IS 360

is under an overhang

• Detection lens must have a clear,

unobstructed view of detection area

• Ideal mounting height is 8-12 feet

Installation

Ensure use of the correct enclosure and

conﬁ rm power is off at the circuit breaker.

• Remove housing cover. Press the two

indentations on side of housing cover,

turn counter-clockwise and pull.

• Backout the 2 fastening screws;

separate sensor housing from

mounting plate.

• Insert the two rubber plugs into the

mounting plate.

• Place the sensor wires through the

knockout in the center of the mounting

plate and connect electrical wires (see

Wiring).

• Align mounting plate with junction box

and secure with j-box screws.

• Realign mounting plate to sensor

housing; secure with fastening screws.

• Reapply and engage the housing cover.

Housing cover

Decorative ring

Mounting plate

Sensor housing

Junction box

1

2

4

3

4

www.steinel.net

(800) 852-4343

www.steinel.net (800) 852-4343

1 2 3 4

Comments to this Manuals

No comments